How to Clean the Inside of Plastic Water Pipes

1 - detergent cleaning method: the mixture of detergent in warm water into the plastic tube, the liquid accounted for a quarter to one-third of the volume of the tube is more appropriate, closed at both ends, shaking vigorously, large plastic pipe can be used to clean the way mechanical vibration. After 20 minutes to half an hour, release the liquid and rinse repeatedly with water. This method is suitable for shorter length and inner wall thickness greater than 1cm of the water pipe.

2 - Superborn cleaning method: suitable for laboratory or special industry use of plastic pipe, the inner wall is closed, and it is not easy to open the plastic pipe, you can use the external superborn vibration method of cleaning. The price of the supernatural life cleaning machine is very good, special industry use.

3-Inner wall scrubbing: use a wire from the middle of the plastic tube through, with a rope to the other end of the plastic tube, if the plastic tube like the thickness of the infuser, you can use the better toughness of the cotton line or fishing line. Cotton thread or rope length is higher than the length of the plastic tube, at one end of the cotton thread or rope tied a ball of cotton, if it is particularly thick plastic tube, you can use than the inner wall of the plastic tube is slightly thinner than the plastic tube as a filler, wrapped in a layer of cotton cloth, towel, or cotton, cotton balls or filler outside the outer cotton is slightly thicker than the inner wall of the plastic tube, so that it is just barely able to pass through from the inner wall of the plastic tube. Wet the cotton or cotton cloth, etc., with a rope at the other end to pull through, the entire inner wall of the plastic pipe is almost clean, if it still looks dirty, change a piece of cotton and then again.

This cleaning method requires the rope through the plastic pipe, so the plastic pipe can not be too long, otherwise it is not good to wear, of course, if there is a good tool, such as very soft cotton thread, and the wall of the plastic pipe is not too thick to allow the magnetic force of the magnet to pass through, you can tie an iron on the cotton thread, with a magnet to guide the advancement of the theoretically unlimited length of the plastic pipe can be achieved. But when the plastic tube is too long, the cotton thread and the inner wall of the plastic tube friction increases, it is not good operation. It is also possible to reduce the friction between the cord and the inner wall of the plastic tube by binding the iron object in sections, but it is difficult to operate.